RALLY wheel disc paint aerosol gold

Colour:

Product code: TE01615

Packaging:

Package: 5pcs.

It is recommended for the painting of the wheel discs and other metal, wood, glass and certain plastic surfaces.

It dries well at room temperature, it is heat-resistant up to 90°C (194°F), it has good hiding power and a metallic surface.

It adheres well also to aluminium surfaces. It ensures appropriate hiding power even in a single layer.

In case of plastics, compatibility test shall be performed. It is sufficient for a surface of 2-2.5 m² (21.5-27 sqft) in a single layer.

Other product info

ADVICE FOR PAINTING, AEROSOL TECHNIQUES

The basis of painting is the appropriate preparation of the surface (polishing, degreasing and roughening), as the new decoration will be durable and of high-quality only on a well-prepared surface.

The paint shall be applied on a cleaned and dry surface, preferably at 20-25°C. Before starting painting, shake the bottle until at least 1 minute to let the material therein homogenise.

Spray the surface evenly and softly from a distance of 20-30 cm (8-12 inch). Even covering can be achieved by cross-spraying. During spraying, cross the border of the surface to be painted in case of each change of direction.

The material in the aerosol is significantly more diluted than the standard paints for the sake of good applicability, therefore, it is prone to streaming. Upon application, ensure to spray only a thin layer at the same time onto the surface. This can be repeated multiple times after a short drying time.

In case of the incidental clogging of the valve or after finishing painting, flush the nozzle with the propellant: operate the bottle upside down for 2-3 seconds.

Make sure of the perfect quality of the MAESTRO aerosol paints and of the usefulness of the recommendations above.

Keep up the good work!

The easier use of the MAESTRO aerosol paints are supported by practical row of pictogram on the can.

Using instructions

Clean the surface to be painted from any contamination.
Perform painting on a dry surface and preferably between 20-25°C (68-77°F).
Shake the bottle for 1 minute after the start of the movement of the balls.
Spray the surface very softly from a distance of about 20 cm (8 inch), which can be resprayed after 5-10 minutes of drying time. It can be painted after 12 hours by RALLY wheel disc lacquer.

In case of the incidental clogging of the valve, operate the bottle by turning the nozzle.
After use, operate the bottle upside down for 2-3 seconds.
The coating will be suitable for use after 40 minutes of drying.