MAESTRO spelter (zinc) aerosol

Colour:

Product code: TE02401

Packaging: 400 ml

Package: 5pcs.

The aerosol is suitable for the durable corrosion prevention of galvanised workpieces and iron containing metals indoors and outdoors.

It makes a light-coloured zinc coating similar to hot dip galvanising, which is weather resistant and heat resistant up to 600°C (1112°F).

It is ideal for spot welding. It adheres well to any metal surfaces and it dries rapidly.

It can be coated by MAESTRO nitro lacquer.

The content of the bottle is sufficient for the single-layer painting of a surface of about 2 m² (21.5 sqft).

Other product info

ADVICE FOR PAINTING, AEROSOL TECHNIQUES

The basis of painting is the appropriate preparation of the surface (polishing, degreasing and roughening), as the new decoration will be durable and of high-quality only on a well-prepared surface.

The paint shall be applied on a cleaned and dry surface, preferably at 20-25°C. Before starting painting, shake the bottle until at least 1 minute to let the material therein homogenise.

Spray the surface evenly and softly from a distance of 20-30 cm (8-12 inch). Even covering can be achieved by cross-spraying. During spraying, cross the border of the surface to be painted in case of each change of direction.

The material in the aerosol is significantly more diluted than the standard paints for the sake of good applicability, therefore, it is prone to streaming. Upon application, ensure to spray only a thin layer at the same time onto the surface. This can be repeated multiple times after a short drying time.

In case of the incidental clogging of the valve or after finishing painting, flush the nozzle with the propellant: operate the bottle upside down for 2-3 seconds.

Make sure of the perfect quality of the MAESTRO aerosol paints and of the usefulness of the recommendations above.

Keep up the good work!

The easier use of the MAESTRO aerosol paints are supported by practical row of pictogram on the can.

Using instructions

The basic surface must be clean, dry and free from rust and grease.
Shake the bottle for 2-3 minutes after the start of the movement of the balls.
Apply the first layer thinly to increase adhesion.
After 10 minutes, the surface can be re-sprayed. The increase in the number of layer increases the corrosion prevention effect as well.
The optimal temperature for application is 20-25°C (68-77°F).

In case of the incidental clogging of the valve, operate the bottle by turning the nozzle.
After use, operate the bottle upside down for 2-3 seconds.

Comments

If you would like to write a comment please sign in!

Questions, answers

If you want to write a question please sign in!

Hobby, DIY paint aerosols

MAESTRO spelter (zinc) aerosol

Other product info

Using instructions

The basic surface must be clean, dry and free from rust and grease.

Shake the bottle for 2-3 minutes after the start of the movement of the balls.

Apply the first layer thinly to increase adhesion.

After 10 minutes, the surface can be re-sprayed. The increase in the number of layer increases the corrosion prevention effect as well.

The optimal temperature for application is 20-25°C (68-77°F).

After use, operate the bottle upside down for 2-3 seconds.

Comments

Questions, answers

Similar products