MAESTRO wall stain cover paint aerosol

Product code: TE02615

Packaging: 400 ml

Package: 5pcs.

The aerosol is suitable for covering/primer painting of a surface of ca. 2.5 m² in one layer. It provides weatherproof, hard but flexible coating of good covering capacity and excellent adhesion.

It can easily adhere to numerous kinds of contamination such as carbon black, nicotine and soaking stains, fatty spots and fully cover them. Thus, the spot covered earlier already cannot show through the paint applied on it.

By using it, you can increase the adhesion, durability and spreading rate of the covering paint. For plastics, and when re-painting already painted surfaces, compatibility test must be performed.

There may be a nuance difference between the colours of the coating and the cap.

Other product info

ADVICE FOR PAINTING, AEROSOL TECHNIQUES

The basis of painting is the appropriate preparation of the surface (polishing, degreasing and roughening), as the new decoration will be durable and of high-quality only on a well-prepared surface.

The paint shall be applied on a cleaned and dry surface, preferably at 20-25°C. Before starting painting, shake the bottle until at least 1 minute to let the material therein homogenise.

Spray the surface evenly and softly from a distance of 20-30 cm (8-12 inch). Even covering can be achieved by cross-spraying. During spraying, cross the border of the surface to be painted in case of each change of direction.

The material in the aerosol is significantly more diluted than the standard paints for the sake of good applicability, therefore, it is prone to streaming. Upon application, ensure to spray only a thin layer at the same time onto the surface. This can be repeated multiple times after a short drying time.

In case of the incidental clogging of the valve or after finishing painting, flush the nozzle with the propellant: operate the bottle upside down for 2-3 seconds.

Make sure of the perfect quality of the MAESTRO aerosol paints and of the usefulness of the recommendations above.

Keep up the good work!

The easier use of the MAESTRO aerosol paints are supported by practical row of pictogram on the can.

Using instructions

Do not use the paint below 10 °C temperature in any way.
It is necessary to clean the surfaces with fatty spots with detergent previously.
Shake the bottle for 1 minute from the start of the balls.
Spray the surface uniformly, lightly from 20-30 cm distance.
When spraying, be careful to spray only one light layer at a time on the surface by means of cross spraying; then you can repeat it several times after the drying time (15-30 minutes) lasts.
In case of any possible valve clogging or when you finish the painting, flush the nozzle with the propellant: operate the bottle with the nozzle facing downwards for 2-3 seconds, while in case of valve clogging, operate the aerosol with the nozzle turned off.