MAESTRO alu-zinc spray

Product code: TE02561

Packaging: 400 ml

Package: 5pcs.

This aerosol can be widely applied for the painting and the durable anti-corrosion protection of metal surfaces both indoors and outdoors.

It is suitable for the correction of injured priming and cold galvanised surfaces as well. It dries and adheres well on every metal surface, it can be re-welded and provides a heat resistant surface up to 100°C (212°F).

The coat can be lacquered with MAESTRO nitro or acrylic lacquer or can be painted by MAESTRO acrylic paint.

The content of the bottle is sufficient for the single-layer painting of a surface of about 2 m² (21.5 sqft).

Subtle differences may appear between the colour of the coating and the lid.

The surface to be sprayed must be clean, dry and free from rust and grease!

Other product info

ADVICE FOR PAINTING, AEROSOL TECHNIQUES

The basis of painting is the appropriate preparation of the surface (polishing, degreasing and roughening), as the new decoration will be durable and of high-quality only on a well-prepared surface.

The paint shall be applied on a cleaned and dry surface, preferably at 20-25°C. Before starting painting, shake the bottle until at least 1 minute to let the material therein homogenise.

Spray the surface evenly and softly from a distance of 20-30 cm (8-12 inch). Even covering can be achieved by cross-spraying. During spraying, cross the border of the surface to be painted in case of each change of direction.

The material in the aerosol is significantly more diluted than the standard paints for the sake of good applicability, therefore, it is prone to streaming. Upon application, ensure to spray only a thin layer at the same time onto the surface. This can be repeated multiple times after a short drying time.

In case of the incidental clogging of the valve or after finishing painting, flush the nozzle with the propellant: operate the bottle upside down for 2-3 seconds.

Make sure of the perfect quality of the MAESTRO aerosol paints and of the usefulness of the recommendations above.

Keep up the good work!

The easier use of the MAESTRO aerosol paints are supported by practical row of pictogram on the can.

Using instructions

Shake the bottle for 2-3 minutes after the start of the movement of the balls.
During use, repeat shaking multiple times.
Evenly and thinly spray the surface of the metal.
To get a higher corrosion resistance, a further layer may be applied after 10 minutes.
It can be repainted with finishing paint or lacquer after at least 3 hours of drying time.

If possible, perform spraying at a temperature of 20-25°C (68-77°F).
In case of the incidental clogging of the valve, operate the bottle by turning the nozzle.
After use, operate the bottle upside down for 2-3 seconds.

Comments

If you would like to write a comment please sign in!

Questions, answers

If you want to write a question please sign in!

Hobby, DIY paint aerosols

MAESTRO alu-zinc spray

Other product info

Using instructions

Shake the bottle for 2-3 minutes after the start of the movement of the balls.

During use, repeat shaking multiple times.

Evenly and thinly spray the surface of the metal.

To get a higher corrosion resistance, a further layer may be applied after 10 minutes.

It can be repainted with finishing paint or lacquer after at least 3 hours of drying time.

Comments

Questions, answers

Similar products